How to keep ebony dolls from being ashy looking?
By u/devinking13
So for those of you who have a ebony doll, or new ebony Daisy, you might have noticed it looked ashy looking after your first wash her, probably because the doll was made a few months ago and needed to be oiled again.
So, if you notice white ashy spots on the ebony tpe, you just need to wash your doll with some hot water, make sure it’s not above 50 degrees Celsius. Rub in some anti-bacteria soap around the ashy areas or just wash the doll entirely. Then rinse and dry off with a towel. Just lightly wipe the tpe because you’re just going to let it air dry when putting the oil.
Now you will get some baby oil/mineral oil and just rub it around the tpe like a massage, my temptation rubbing oil around her ass was hard to hold back when it’s nice and wet lol.
I wipe the oil in sections to let it seep in the tpe without the oil getting everywhere. I rub it in doggy position first, wait like 10 min then flip her over missionary, and rub it in, wait 10 min. Then rub the cut off from the stomach and legs. Then wait 10 min.
Finally you put your cornrstarch/baby powder and she should look good as new😁👍
Now because she is ebony, when you touch the tpe you will see your hand prints but if you do these instructions the hand prints fade, it’s just the powder on the tpe so it’s bound to happen.
So basically just make sure probably (once a month) to oil her or if you notice the ash coming back, it depends how often you use and wash and repeat after a session with your doll. Should probably oil no more than twice a month if you use her often.
